Intelix FLX-44 Bedienungsanleitung PDF herunterladen (Seite 14)

FLX-44 Installaon Guide

Connect RS232 Control

In addion to tradional RS232 control, the FLX-44 has an advanced RS232 control mechanism which allows RS232

tunneling and roung through the HDBaseT output port to control remote devices. Intelix recommends using the

DIGI-HD60C-R for installaons which require RS232 extension.

See page 27 for all available control commands for the FLX-44.

Matrix Control via RS232

Remote RS232 Control via Tunneling

The RS232 control port requires a standard straight-through serial cable for operaon. The default sengs for the

RS232 port are:

• 9600 baud

• 8 Data Bits

• 1 Stop Bit

• Parity = none

Connect a standard straight-through serial cable with DE9 connector

between the RS232 port on the FLX-44 and the controller.

Discrete remote control of remote display devices is possible by connecng an RS232 output of a control system

to the 3-pole terminal block on the output of the matrix. A compable HDBaseT with control receiver is required

to pass the control signals to the display devices.

To use the RS232 extension capabilies of the FLX-44, connect the TX, ground, and RX control signal wires to the

removable 3-pole terminal block. Consult the manual of the control device(s) to determine which pins the TX/RX

signals are carried on. Be sure to always connect TX to RX and RX to TX.

RXD

GND

TXD

FLX-44Controller

TXD

GND

RXD

DIGI-HD60C-R Display

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Keine Kommentare

Intelix FLX-44 Bedienungsanleitung Seite 14