Intelix DIGI-P52 Bedienungsanleitung PDF herunterladen (Seite 15)

DIGI-P52 Installaon Guide

Connect IR Control (Oponal)

Source Device and Scaler Control via Remote IR

Aach the plasc end of the DIGIB-EMT to the IR receiver of the

source device. Insert the TS 3.5 mm plug of the DIGIB-EMT to

the IR output port (IR OUT) of the matrix for the source device

to control.

The DIGI-P52 has an advanced bidireconal IR control protocol through the HDBaseT output port, which allows

for the control of the sources, displays, and presentaon switcher. Intelix recommends using the DIGI-HD60C-R

for installaons which require IR extension.

Only use the included IR components, DIGIB-EMT (IR transmier) or DIGIB-EYE (IR receiver) with the DIGI-P52.

Third party 12V DC IR components are not compable with the DIGI-P52.

An IR signal passed from the display locaon through the HDBaseT connecon can provide control of the

source device. The IR signal from the remote display locaon can also control the switching of the scaler.

Remote Display and Scaler Control via Local IR

Insert the TRS 3.5 mm plug of the DIGIB-EYE to the IR input port

(IR IN) of the scaler.

An IR signal may be passed to a remote display locaon through the HDBaseT connecon. In order to control

the DIGI-P52 via IR or extend an IR signal to a remote display, the included DIGIB-EYE must be connected to the

IR input port (IR IN) of the scaler.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Keine Kommentare

Intelix DIGI-P52 Bedienungsanleitung Seite 15